Outbound Routes
To define a new outbound protocol to send commands to remote software or devices, click New Outbound at the top left of the interface. This will allow for protocols to be defined.
Each outbound protocol will be auto-saved meaning you can carry on from where you left off between sessions without having to re-define outputs. Removing outbound protocols is as simple as pressing the ‘X’ next to the output you want to delete on the left hand side of the interface.
MIDI Musical
All MIDI devices available will be displayed within the device list.
Select a device and click confirm to save the route.
MIDI SysEx
All MIDI devices available will be displayed within the device list.
Select a device and click confirm to save the route.
OSC
A destination IP and port number between 0 and 65000 must be defined in the format:
(IP:Port), for example 127.0.0.1:53000
Once entered, click confirm to save the route.
HTTP
A destination IP must be defined and optionally a port number between 0 and 65000 in the format:
(IP:Port), for example 127.0.0.1:8080 (port defaults to 80 if not provided)
Once entered, click confirm to save the route.
HTTPS
A destination IP must be defined and optionally a port number between 0 and 65000 in the format:
(IP:Port), for example 127.0.0.1:8443 (port defaults to 443 if not provided)
Once entered, click confirm to save the route.
TCP
A destination IP and port number between 0 and 65000 must be defined in the format:
(IP:Port), for example 127.0.0.1:8000
Once entered, click confirm to save the route.
UDP
A destination IP and port number between 0 and 65000 must be defined in the format:
(IP:Port), for example 127.0.0.1:8000
Once entered, click confirm to save the route.